Roofing Contractor in Farmersville, TX | Pillar Roofing

Before spraying the final roof coating, we prepare and reinforce every vulnerable detail. Areas showing corrosion receive rust inhibitor to stabilize the metal and stop deterioration from continuing beneath the new system. We then triple-seal around every turbine, HVAC curb, penetration, transition, and other roof fixture, carrying the reinforced coating completely around each base to create a continuous watertight barrier.

Every exposed hex-head screw is also inspected and individually covered with a white “Hershey Kiss” of coating. These seals protect the screw heads and aging neoprene washers from further weather exposure while closing thousands of potential water-entry points across the roof.

Only after the rust, hardware, seams, and fixtures have been thoroughly prepared do we apply the full spray coating. That careful sequence is what turns an aging metal-panel roof into a complete restoration system—not merely a fresh coat of paint.

When a roof is too steep or unsafe to walk on, your Pillar Roofing Concierge will launch the inspection drone, allowing us to complete a thorough inspection without putting anyone at unnecessary risk.

High-resolution aerial photography captures the same important details we would document while walking the roof—damaged shingles, failing pipe jacks, drainage concerns, flashing defects, and other imperfections.

Best of all, you receive a clear view of something you may have never seen before: your entire roofing system from above, complete with our findings and professional recommendations.

Most homeowners are shown a shingle color and handed an estimate.

We take a different approach. During our 10-Minute Driveway Demo, your Pillar Roofing Concierge lays out the actual pieces and parts that make up a complete roofing system—from shingles and underlayment to ice and water shield, drip edge, pipe jacks, ventilation, flashing, and fasteners.

In just a few minutes, you will understand how a roof is assembled, why each component matters, and exactly what will be installed on your own home. It is a simple, hands-on lesson that helps you make a confident decision before the first shingle ever comes off.

We evaluate your Attic using a thermal temperature beam and smoke dispersion to identify heat buildup, air leaks, drafts, blocked pathways, and areas where air has become trapped.

Using our findings, we will recommend a balanced Proactive ventilation solution for the Attic.

Solutions include: cleaning or replacing clogged soffit vents, adding more soffit vents, removing insulation blocking airflow, and upgrading to a more proactive ventilation system with moving parts that create air circulation, measured in cubic feet per minute (CFM).

The goal is to move the air from the bottom of your attic to the top, where the exhaust will push it out. If this process starts early in the morning, it will dramatically lower the "Heat Gain" in your attic later in the day.

Instead of waiting for heated air to escape on its own, a proactive solar attic fan system continuously pulls hot air out of the attic, reducing heat and humidity.

Every Install, Documented

Once the ARC Coating Process has been completed, your Pillar Roofing Coordinator will generate the final invoice for the project.

Before & After photos are included, creating a permanent record for your building’s maintenance files—and giving owners and property managers confidence that the work was completed properly.